What to bear in mind when positioning and levelling the Siemens washing machine

A Siemens washing machine is a large, heavy appliance. When positioning it, it is therefore important to ensure that the requirements for the installation location are met. We show you how to correctly position and level the Siemens washing machine to minimise noises and vibrations and stop the appliance shifting while in use. We also explain how to correctly adjust the feet of the appliance to keep your Siemens washing machine stable and ensure it runs smoothly. This not only prevents noise, but also the risk of piles of laundry accumulating unchecked.

Requirements for the installation location

The appliance may "wander" when it spins. Observe the instructions for the installation location.

Note:

Observe the information on safety and preventing material damage.

st4safety WARNING - Risk of electric shock!
  • The appliance contains live parts.
Touching live parts is dangerous.
  • Do not operate the appliance without a cover cap.
st4safety WARNING - Risk of injury!
  • When using the appliance on a base, the appliance may tip over.
  • Always secure the feet of the appliance to a base using the manufacturer's fixing brackets before using the appliance for the first time.
st4safety ATTENTION!
  • If residual water in the appliance freezes, this may cause damage to the appliance.
  • Do not install or operate this appliance anywhere that is liable to experience frost or outdoors.
  • If the appliance is tilted at an angle greater than 40°, residual water may leak out of the appliance and cause material damage.
  • Tilt the appliance carefully.
  • Transport the appliance in an upright position.

Installation location

Requirements

Base

st4image

Secure the appliance with fixing brackets.

Wooden joist floor

st4image

Place the appliance on a water-resistant wooden board (minimum thickness of 30 mm) which is screwed tightly to the floor.

Kitchen unit

st4image

Only install the appliance underneath a continuous worktop that is securely connected to adjacent cabinets. Required niche width: 60 cm.

Against a wall

st4image

Do not trap the power cord or the hoses between the wall and the appliance.

Levelling the washing machine

In order to reduce noise and vibration and to prevent the appliance from moving, align the appliance correctly.

Note:

Observe the information on safety and preventing material damage.

  1. Use a WAF 17 wrench to loosen the lock nuts in a clockwise direction.

    st4image

  2. To align the appliance, turn the appliance feet. Check that the appliance is level using a spirit level.

    st4image

    All appliance feet must stand firmly on the ground.

  3. Use a WAF 17 wrench to tighten the lock nuts against the housing until they are hand-tight.

    st4image

    In doing so, hold the foot tight and do not adjust its height.

Was this article helpful?

Yes No

Thank you for your feedback.

Thank you for your response. Please let us know how we can improve the article.

Need a repair?

Our trained service engineers will visit your home and resolve the issue on-site. Repairs under the manufacturer’s warranty are carried out free of charge. We also offer reliable support beyond the warranty at transparent and fair conditions. Learn more about repair options, warranty coverage, costs, and how to book a service visit.

Repair service